Mesh via WAP IW6300

[Alibek]

Hi all

We deployed Mesh via WAP IW6300/WLC Catalyst 9800-80

But the download is low. Loading is normal. How to achieve the same rx and tx at both ends

DownloadUpload

[marce1000]

 - Have a look at : https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/214749-tac-recommended-ios-xe-builds-for-wirele.html 

                            Not directly related topic but always useful : 

  -  Review the 9800-80  configuration with the CLI command : show  tech wireless , have the output analyzed by  https://cway.cisco.com/tools/WirelessAnalyzer/  , please note do not use classical show tech-support (short version) , use the command denoted in green for Wireless Analyzer

 M.

[Alibek]

Hi marce1000,

Thanks for the feedback. I will open an official case for tech support

[marce1000]

 - That's ok , you can already execute my configuration review (too) , as explained in initial reply -> It will give you lots of insights.

 M.

[Alibek]

Hi all, Me again,

Question. Is this antenna AIR-ANT2547V-N-HZ compatible with the IW6300-H-AC-E-K9 for the deployment of MESH?

[Alibek]

and in which slot is it recommended (A, B, C, D) to connect the MESH method to the antenna? 

[Alibek]

up