mobility express - AP image 8.10.151.0 led status enable/ disable

[tc4679]

Hi all,

when running mobility express on AP 3802i acting as wlc with image 8.10.151.0 , it appears the option to enable/ disable the led status has been removed from the cli

wlc-ap#
wlc-ap#config ap ?
auxiliary-client Configure auxiliary-client interface VLAN
client-trace Configure Client Trace
cloud Configure cloud servers
tls Configure TLS tunnel
wlc-ap#config ap

previous versions 8.5.x you were able to enable/ disable from the cli, there also does not appear to be an option to do this in the ME Gui

Any thoughts?

Cheers

tc

[balaji.bandi]

as per 8.10 document command still there :

https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-10/cmd-ref/b-cr810/config_commands_a_to_i.html#wp3622663875

[Rich R]

@balaji.bandi that's the WLC command reference.

But is also still there in the ME command ref:

https://www.cisco.com/c/en/us/td/docs/wireless/access_point/mob_exp/810/cmd_ref/me_cr_book-810/m_lwap_cli.html#wp3622663875

@tc4679 have you tried typing it? (regardless of whether ? works)

The following example shows how to enable the LED state for an access point:

(Cisco Controller) >config ap led-state enable AP02

[balaji.bandi]

yes you right i have provided WLC command refence, i do not see major different in command level i guess..(but i accept that WLC command )

[tc4679]

I wonder if it has to do with the fact the the new WLC 9800 series CLI has gone down the path of the traditional IOS cli interface rather than the (cisco controller)# interface. Either way this command wont take on the cli. The primary AP acting as the controller has the look and feel of the traditional IOS cli like a switch or router, the APs are all on the same firmware version 8.10.151.0 see snippet below and the commands do not work on this version. it appears as if this feature has been removed? 

AP Running Image     : 8.10.151.0
Primary Boot Image   : 8.10.151.0
Backup Boot Image    : 8.5.182.0
Primary Boot Image Hash:
Backup  Boot Image Hash: 04e936fb71da1413b1f747258c96516ba6405e26ed7bc4efb90c5f667664c2117cfb869f8b8ab116a26760dbc9bd2c1484f94fbcc18cfb78aa2d57d37bd27b87
AP Image type    : MOBILITY EXPRESS IMAGE
AP Configuration : MOBILITY EXPRESS CAPABLE
1 Multigigabit Ethernet interfaces

wlc-ap#config ap led-state enable
                      ^
% Invalid input detected at '^' marker.
wlc-ap#

[tc4679 · Accepted solution]

ok will close off this thread, the issue was I was logged into the AP itself and not the WLC duh! no more late nights  

[balaji.bandi]

i can understand inceptions - need fresh air break all time when things not working on ourway.