11-23-2020 02:47 PM - edited 07-05-2021 12:49 PM
I have some guest clients that are having to re-webauth every time they boot up or resume from sleep. I'm wondering if there is a CLI setting in Mobility Express that I can use to modify this behavior. Ideally, I'd like the controller to remember guest clients for a few days before requiring re-webauth. Thanks!
Mobility Express 8.10.142.0
Solved! Go to Solution.
11-23-2020 05:01 PM - edited 11-23-2020 05:04 PM
Found these commands:
config wlan disable X
config wlan custom-web sleep-client enable X
config wlan custom-web sleep-client timeout X 10080
config wlan enable X
Where "X" is the WLAN ID.
Timeout is 10080 minutes which is 7 days.
show custom-web sleep-client summary
Shows "sleeping" clients
Seems to do what I wanted.
11-24-2020 03:28 PM
Update:
It appears this actually does not work properly on my 3800 with Mobility Express.
Although clients are registered as sleeping clients, when they reconnect, they are still redirected to the webauth portal.
11-23-2020 05:01 PM - edited 11-23-2020 05:04 PM
Found these commands:
config wlan disable X
config wlan custom-web sleep-client enable X
config wlan custom-web sleep-client timeout X 10080
config wlan enable X
Where "X" is the WLAN ID.
Timeout is 10080 minutes which is 7 days.
show custom-web sleep-client summary
Shows "sleeping" clients
Seems to do what I wanted.
11-24-2020 03:28 PM
Update:
It appears this actually does not work properly on my 3800 with Mobility Express.
Although clients are registered as sleeping clients, when they reconnect, they are still redirected to the webauth portal.
11-24-2020 05:10 PM
11-25-2020 05:14 AM - edited 11-25-2020 05:17 AM
Correct, just this SSID. Same network.
Client is a Chromebook if that changes anything (it shouldn't matter)
I don't have support so all I can do is ask questions here.
I figure it's a bug in ME. Doesn't seem to be the most polished software in my few years of experience with it.
Thanks anyway.
11-25-2020 08:22 AM
11-30-2020 10:49 AM - edited 11-30-2020 10:52 AM
When I do a "show wlan X", I have these settings:
Exclusionlist Timeout............................ 180 seconds
Session Timeout.................................. 86400 seconds
User Idle Timeout................................ Disabled
Sleep Client..................................... enable
Sleep Client Timeout............................. 10080 minutes
Sleep Client Auto Auth Feature................... Enabled
Are you saying I should change these?
Thanks.
11-30-2020 10:00 PM
12-01-2020 07:31 AM
What if I disable both (if it allows that)?
Would that work?
12-01-2020 07:45 AM
11-23-2020 05:14 PM
11-24-2020 12:27 AM
check this posts and follow the CLI commands:
Regards
Dont forget to rate helpful posts
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide