cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
177
Views
0
Helpful
1
Replies
Anand Thakur
Beginner

Move LWAPP form new version WLC to old version WLC?

Hello,

I have a Cisco 2500 series WLC with SW ver. 7.4.110.0. there are more that 10 LWAPPs registered in it.

I want to move them to an old WLC runing SW ver 7.0.240.0.

I need to do this because we purchased some new 2600 series LWAPPs that are supported only above WLC ver. 7.2. But on the sites where the new LWAPPs are purchased there we have the old WLC installed and some old LWAPPs are registered on the WLC. I want to move the old LWAPPs to the 2500 WLC. But when i SSH the LWAPPs and configure the controller IP of the old version WLC nothing happenes.

How to go about the switchover?

Thansk in advance.

Regards,

Anand

1 REPLY 1
Leo Laohoo
VIP Community Legend

But when i SSH the LWAPPs and configure the controller IP of the old version WLC nothing happenes.

Go to the controller and manually configure the primary WLC and IP address of each AP.

Content for Community-Ad