cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
263
Views
0
Helpful
2
Replies

Moving config from 2106 to 2125

sysadmin
Beginner
Beginner

I am replacing a 2106 with a 2125 WAC. I uploaded the 2106 config and want to down load it to the 2125. Is there some way to break out of the config wizard on the 2125 after I give it an address and login information so I can download the config from the 2106?

2 Replies 2

Leo Laohoo
VIP Community Legend VIP Community Legend
VIP Community Legend

During the bootup of the 2125, when you are asked for the username password, enter "recovery-password".

Stephen Rodriguez
Cisco Employee
Cisco Employee

No, you have to go through the full setup wizard and let the WLC reboot.  Once this has happend, then you can download the config to the new WLC.

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers