cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
745
Views
0
Helpful
2
Replies

MSE config SSH,Very urgent

HI MSE Expert;

 

I want to know how to config the MSE about syslog server .I don't config it before,so,i want to open it.

I have find this info as below:

#######################

Configuring the Remote Syslog Server to Publish MSE Logs

Use this option to configure a remote syslog server by specifying the IP address, priority parameter, priority level, and facility.

Example:


A Remote Syslog Server has not been configured for this machine.
Configure Remote Syslog Server Configuration parameters? (Y)es/(S)kip/(U)se default [Skip]: y
Configure Remote Syslog Server IP address: 283.12.13.4

Configure Remote Syslog Server Priority parameter.
select a priority level
1)ERROR (ERR)
2)WARNING
3)INFO
Enter a priority level (1-3) :2
Configure Remote Syslog Server's Facility parameter.
Select a logging facility
  		KERN(0), // Kernel messages
  		USER(1), // user-level messages
  		MAIL(2), // mail system
    DAEMON(3), // system daemons
    AUTH(4), // security/authorization messages (note 1)
    SYSLOG(5), // messages generated internally by syslogd
    LPR(6), // line printer subsystem
    NEWS(7), // network news subsystem
    UUCP(8), // UUCP subsystem
    CRON(9), // clock daemon (note 2)
    SECURITY(10), // security/authorization messages (note 1)
    FTP(11), // FTP daemon
    NTP(12), // NTP subsystem
    LOGAUDIT(13), // log audit (note 1)
    LOGALERT(14), // log alert (note 1)
    CLOCK(15), // clock daemon (note 2)
    LOCAL0(16), // local use 0  (local0)
    LOCAL1(17), // local use 1  (local1)
    LOCAL2(18), // local use 2  (local2)
    LOCAL3(19), // local use 3  (local3)
    LOCAL4(20), // local use 4  (local4)
    LOCAL5(21), // local use 5  (local5)
    LOCAL6(22), // local use 6  (local6)
    LOCAL7(23); // local use 7  (local7)

Enter a facility(0-23) :4

#######################################

But, i don't know how to enter the CLI.Please help me to solve this issue,thanks a lot!

 

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Rps-Cheers | If it solves your problem, please mark as answer. Thanks !
1 Accepted Solution

Accepted Solutions

You have to run automatic installation script at any time to add or change parameters using this command:
[root@mse]# /opt/mse/setup/setup.sh. 
There is no need to re-enter values that you do not want to change during one of these updates.

 

HTH

Rasika

*** Pls rate all useful responses ***

View solution in original post