I've setup a WLSE to auto-configure a new AP (set opts 66 & 67 in the DHCP server) so that the WLSE detects and manages a new AP when it's first powered on. The only thing I haven't managed to make it do is assign a unique name and the correct ststic IP address to the AP's, I have to do this part manually.
Is there any way this can be built into the WLSE templates?
Since the templates are designed for mass deployment there is not a value for hostname and IP address under the predefined options. You can define a template for a specific device and enter these commands in the custom values. Remember that the custom values are not validated by wlse and syntax is not checked.
Hello Community, I have an issue where APs do not connect to the WLC. Connection is made over VPN. Until yesterday all 3 APfailed with below errors. We change the LAN connection to a cisco router and now one of the AP magically connected to the...
Where to download
Attached files on this post
Alternatively, cloud version (only summaries)
New implementation for the WLC Config Analyzer. it is a new re-write of the application, with clean up and improved checks
Support for IOS...
Cisco Champion Radio · S8|E6: Fastlane+ Optimizes Network and Device Communication
Cisco Fastlane+ is a co-developed solution with Apple that significantly improves the experience of any Wi-Fi 6 capable iPhone or iPad connected to a Cisco Catalyst 9130 A...
We are pleased to announce the immediate availability of the IOS-XE release 17.4.1 for the Catalyst Wireless Controllers. The new code is now posted on the CCO and can be found at this link:
Table of Contents
The purpose of this document is to provide step-by-step instructions regarding how to connect your read-only Catalyst 9800 WLC or AireOS WLC with Cisco DNA Center for Assurance monitoring through manual configuration. I...