I've setup a WLSE to auto-configure a new AP (set opts 66 & 67 in the DHCP server) so that the WLSE detects and manages a new AP when it's first powered on. The only thing I haven't managed to make it do is assign a unique name and the correct ststic IP address to the AP's, I have to do this part manually.
Is there any way this can be built into the WLSE templates?
Since the templates are designed for mass deployment there is not a value for hostname and IP address under the predefined options. You can define a template for a specific device and enter these commands in the custom values. Remember that the custom values are not validated by wlse and syntax is not checked.
I have a test network with a Cisco 2504 WLC and 1142N access points. I am just beginning to study for the Wi-Fi certification. I have a connection to 2504 WLC. AP is joined to WLC. When I connect to the Wi-Fi, it says, "connected without internet".I am ne...
Hi I have a guest SSID with CWA configured on a C9800 with AP9115AX and i want to override all DSCP Values to 0 for all packets to and from the wifi clients.i have tried a lot of configurations and a can drop traffic or shape traffic based on ACL or ...
We are pleased to announce the immediate availability of the IOS-XE release 17.4.1 for the Catalyst Wireless Controllers. The new code is now posted on the CCO and can be found at this link:
Table of Contents
The purpose of this document is to provide step-by-step instructions regarding how to connect your read-only Catalyst 9800 WLC or AireOS WLC with Cisco DNA Center for Assurance monitoring through manual configuration. I...
Securing devices without 802.1X
PSK (Pre-Shared-Key) WLAN is widely used for consumer & enterprise IoT onboarding as most of IoT device doesn’t support 802.1X. While PSK WLAN provides an easy way to onboard IoT, it also introduces challenges as...