09-04-2017 01:58 AM - edited 07-05-2021 07:36 AM
Hi there!
Just wondering if it's possible to configure a 2600 series AP with Netflow to send traffic flows.
I have several AIR-SAP2602I-E-K9's , operating autonomously.
Software Version:
ap3g2-k9w7-xx.153-3.JBB |
Can't find much documentation on this. Looking like I would need a controller for this perhaps?
Any help appreciated!
Thanks
Solved! Go to Solution.
09-04-2017 03:03 AM
Netflow is only supported on L3 device. So you cannot configure AP to send netflow data (as AP is a L2 device)
You have to configure netflow on the device where you defined SVI for wireless users.
HTH
Rasika
*** Pls rate all useful responses ***
09-04-2017 03:03 AM
Netflow is only supported on L3 device. So you cannot configure AP to send netflow data (as AP is a L2 device)
You have to configure netflow on the device where you defined SVI for wireless users.
HTH
Rasika
*** Pls rate all useful responses ***
09-04-2017 03:06 AM
Makes sense. Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: