06-25-2012 02:45 AM - edited 07-03-2021 10:20 PM
Hi,
I have added few new access points to our wireless network. We have an existing WCS.
what steps are required to add the new access points on the wcs so the maps reflect the new ones.
Thanks in advance.
Solved! Go to Solution.
06-25-2012 05:53 AM
Hi,
Here are the steps:
http://www.cisco.com/en/US/docs/wireless/wcs/7.0/configuration/guide/7_0maps.html#wp1126390
HTH
Amjad
06-25-2012 05:53 AM
Hi,
Here are the steps:
http://www.cisco.com/en/US/docs/wireless/wcs/7.0/configuration/guide/7_0maps.html#wp1126390
HTH
Amjad
04-28-2013 10:34 PM
Case Solution:
Step 1 Choose Monitor > Maps.
Step 2 From the Maps Tree View or the Monitor > Maps list, click the applicable floor to open the Floor View page
Step 3 From the Select a command drop-down list, choose Add Access Points, and click Go.
Step 4 On the Add Access Points page, choose the access points to add to the map.
Step 5 Click OK to add the access points to the map and display the Position Access Points map
Step 6 When all of the applicable access points are selected, click OK located at the bottom of the access point list.
Step 7 Click and drag each access point to the appropriate locations. Access points turn blue when selected.
Step 8 When you are finished placing and adjusting each access point, click Save.
For more information please review the below link:
http://www.cisco.com/en/US/docs/wireless/wcs/7.0/configuration/guide/7_0maps.html#wp1126390
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide