No IP Adress for a 1252 AP

[Andreas_Seybold-Epting]

Hello to all,

I have a Problem with some 1252 AP.

We have installed in a Branch two 4402 (25) Controller. Both Controller work without Problems. We have also installed some other AP´s on this Controller.

Version is 7.0.98

Now my Problem. I Connect a AP´s to a HP Switch but the AP dos not get a IP.

I can see with a console Cable that is a message: AP can not join to the Controller because he has no IP.

In The DHCP is a Reservation for this AP. When i delete this Reservation the AP dosn´t also get a IP.

We have flashed this AP bot without result.

Dos anyone know this Problem?

Thanks for your help.

Regards

Andreas

[George Stefanick]

Plug your PC into that port (where the ap is at), can you pull an IP on your PC?

[Andreas_Seybold-Epting]

Hi George Stefanick

thanks for your answer.

I get a IP with a PC. This is not a Problem.

[George Stefanick]

Is it getting an IP, but just not finding the controller? Can you capture the output and post it ?

[Andreas_Seybold-Epting]

Hi Stefanick,

thanks for you Answer. I have found the Problem. On this AP was the Network Modul defect. Cisco change this AP.

Thanks for you Help.

Regards

Andreas