cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
374
Views
0
Helpful
3
Replies
laukik.nahar1
Beginner

Not able to configure the Access Point in standalone.

Hi,

Have upgrade the IOS to ap3g2-k9w7-tar.153-3.JD

Please find the attached file for configuration done on Standalone AP.

I'm able to connect to Access Point using pre-shared key , but my Access point is not able to ping default-gateway , access switch or even DHCP server.

Need help for verification of the configuration and please share what more changes are required.

Also need to configure 3 Standalone AP's in mobility. It would be very helpful anyone can provide references.

Thanks

Laukik.

3 REPLIES 3
Kundan Prasad
Beginner

remove these commands and then try pinging it..

ipv6 address dhcp
ipv6 address autoconfig
ipv6 enable

Hi Kundan,

Tried changing the above configuration , still not working.

Thanks,

L

i would suggest to reset the AP and start the config again from scratch.

Regards

Dont forget to rate helpful posts

Content for Community-Ad