08-11-2022 02:14 AM
Good Day,
I have an SSID’s not broadcasting issue:
WLC Model:
AIR-CT5520-K9
Software Version:
8.3.150.0
This Outdoor AP is broadcasting and users are connecting
AIR-AP1572EAC-E-K9
Primary software ver:
8.3.150.0
Boot Ver:
15.3.0.0
IOS Ver:
15.3.(3)JD1$
And these software versions is correct according Cisco’s WLC compatibility website.
According to the users below AP is not broadcasting any SSID’s
AIR-AP1562E-E-K9
Primary software ver:
8.3.150.0:
IOS Ver
8.3.150.0
Unless I am mistaken I suspect above IOS Ver is the cause? and not sure why the WLC did not push / AP did not pull the correct IOS Ver?
Any suggestions?
Thanks & Regards
08-11-2022 02:41 AM
Are the of each AP's radios enabled?
08-11-2022 03:02 AM
Hi Leo,
Thank you for the reply - yes the problematic AP has both Radio's:
802.11b/g/n
802.11a/n/ac
Both Admin Status is enabled & Oper Status UP
08-11-2022 03:20 AM
08-11-2022 04:22 AM
08-11-2022 04:38 AM
Is this AP a member of an AP group?
08-11-2022 05:18 AM
They AP is added in the required SSID group
08-11-2022 05:22 AM
also I used command:
capwap ap primary-base WLC*WLC NAME* WLC IP*
if it is going to make any difference
08-15-2022 04:41 PM
And what antenna is the 1562 using?
08-15-2022 05:08 PM
can you also paste these outputs
show ap wlan 802.11a <AP name>
show ap wlan 802.11b <AP name>
grep include "AP name" "show advanced 802.11a summary"
grep include "AP name" "show advanced 802.11b summary"
08-16-2022 06:19 AM
Which mode (local, Flex, mesh) the 1562 AP is in? It doesn't support mesh mode in this version.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide