03-05-2021 07:18 AM - edited 07-05-2021 01:19 PM
Hi expert
I convert my Cat 9120 AP to EWC.
Then I try to provision it using iPad by Over-the-Air Provisioning (OTAP).
But the configured SSID doesn't appear in my laptop, iPad, smartphone.
But in CLI, I can see the SSID already up.
Does anyone know what is the problem?
03-05-2021 12:09 PM
did you check radios(2.4GHz, or 5.0GHz) are up?
Rasika
03-06-2021 08:56 AM
Hi Rasika
How to check it?
What command that I need to apply in CLI?
03-06-2021 11:27 AM
Make sure you follow the guide. You need to make sure you define the country code and then enable the radios. Also, depending on what image the ap has, the provision ssid sometimes work and doesn’t. That is from my experience. You can also hold the mode button down and power cycle the ap. Keep holding the mode button for 20 seconds or until the led blinks red. If the ssid doesn’t appear, then use the cli to configure the EWC.
03-06-2021 01:56 PM
Hi Anwar Safian,
Please check your this command and sharing with us : show ip interface brief
Check: dot11radio interface 0 and 1
Or
Wlan 0 and 1 interfaces.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: