cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
560
Views
0
Helpful
3
Replies

P2P Blocking Drop on WLC will be ignored

ciscoprolin
Level 1
Level 1

Dear All,

we have enabled P2P Blocking Drop on our WLCs for the SSID xxx.

But the Clients still see each other and can ping each other.

Any idea ? Cisco Bug ?

Thanks,

Thorsten

2 Accepted Solutions

Accepted Solutions

Is this across multiple WLCs ? I think this feature works for clients on same WLC

HTH

Rasika

View solution in original post

HI,

You can use  ACL on the dynamic interface.It might impact the performance****

check this post about ACL config:

https://supportforums.cisco.com/discussion/10826006/howto-block-p2p-traffic-clients-connected-same-ssid-different-wlc

Regards

Dont forget to rate helpful posts

View solution in original post

3 Replies 3

Is this across multiple WLCs ? I think this feature works for clients on same WLC

HTH

Rasika

Dear Rasika,

thanks. Yes we have 2 WLCs with both WLCs being active. When I first activated the feature it was not possible to see other clients. But in the meantime now that we are running version 8.2.131.0 this is again possible.

Is there a way to stop the clients from seeing each other if this feature doesn't work for multiple WLCs ?

Thanks a lot,

Thorsten

HI,

You can use  ACL on the dynamic interface.It might impact the performance****

check this post about ACL config:

https://supportforums.cisco.com/discussion/10826006/howto-block-p2p-traffic-clients-connected-same-ssid-different-wlc

Regards

Dont forget to rate helpful posts

Review Cisco Networking for a $25 gift card