03-04-2013 12:03 PM - edited 07-03-2021 11:40 PM
Can someone please advise how I can audit my wired network device configurations using configuration templates I have configured in PI 1.2? I do not want to deploy the templates that would make changes on my devices, but would like to see a diff report that indicates each device and which config lines do not match the template. Basically I want to get a list of devices that are out of compliance before I deploy any templates.
Thanks
Chris Kaufman
03-04-2013 03:20 PM
Typically you create a controller group and you apply the templates to that group for PI to determine if there is a configuration mismatch. Only the templates used will be used to determine a mismatch. This link should help.
http://www.cisco.com/en/US/docs/wireless/prime_infrastructure/1.2/configuration/guide/ctrlcfg.html#wp1098631
Sent from Cisco Technical Support iPad App
03-05-2013 07:31 AM
Thanks Scott, but I need to clarify that I want audit the configurations of my wired network devices.
03-06-2013 12:51 PM
Hello,
You may follow the below steps:
Step 1 Choose Configure > Scheduled Configuration Tasks.
Step 2 From the left sidebar menu, choose ConfigGroup.
Step 3 Select the group name of the applicable task.
Step 4 From the Config Groups page, click the Apply/Schedule tab.
Step 5 Make any necessary changes to the current schedule, and click Schedule.
or you can use this reference guide:
www.cisco.com/en/US/docs/wireless/prime_infrastructure/1.2/configuration/guide/ctrlcfg.html#wp1098631
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide