cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1278
Views
0
Helpful
2
Replies

PoE status of access points

Not applicable

Some of Cisco AIR-CAP3702I-A-K9 access points at PoE status shows "PoE/Medium Power (15.4 W)".  Other access points at PoE status shows "PoE/Full Power" on the same Cisco switch.

PoE switch is Catalyst WS-C4510R+E with dual power supply 6000W/each.

Any thoughts on this situation.  Thanks,

2 Replies 2

Leo Laohoo
VIP Community Legend VIP Community Legend
VIP Community Legend

If they are connected to the switch, then post the complete output to the command "sh power inline | i AIR". 

pwwiddicombe
Enthusiast
Enthusiast

Are they all connected to the same linecard?  Some support PoE+ and can supply the 18W or so that's preferable to the 3702 and other AP's.

If they can't allocate that, they will fall back, but run fewer internal radios and drop a spatial stream if only the 15.4w is available.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers