Ports - Cisco Prime Infrastructure UCS Physical HW Appliance (Gen 3)

[adeebtaqui]

Hi,

I am not able to find details about interfaces available on Cisco Prime Infrastructure UCS Physical HW Appliance (Gen 3).

Does this have SFP+ ports? Or just 10G Copper ports?

[Rasika Nayanajith]

As per this, it only got two 1/10 Gbps Ethernet ports

https://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/3-8/hardware_install/guide/bk_Cisco_Prime_Infrastructure_3_8_Appliance_Hardware_Installation_Guide/bk_Cisco_Prime_Infrastructure_3_8_Appliance_Hardware_Installation_Guide_chapter_00.... 

It is based on UCSC220M5 series and you can find it is spec here too

https://www.cisco.com/c/dam/en/us/products/collateral/servers-unified-computing/ucs-c-series-rack-servers/c220m5-sff-specsheet.pdf 

HTH

Rasika

*** Pls rate all useful responses ***

[adeebtaqui · Accepted solution]

Thankyou @Rasika Nayanajith 

Found below info in server doc shared by you.

Interfaces ■ Rear panel
• One 1Gbase-T RJ-45 management port (Marvell 88E6176)
• Two 10Gbase-T LOM ports (Intel X550 controller embedded on the
motherboard)
• One RS-232 serial port (RJ45 connector)
• One DB15 VGA connector
• Two USB 3.0 port connectors
• One flexible modular LAN on motherboard (mLOM) slot that can
accommodate various interface cards
■ Front panel
• One KVM console connector (supplies two USB 2.0 connectors, one
VGA DB15 video connector, and one serial port (RS232) RJ45
connector)

---

 

[Carlos Rogerio Souza Santos]

@Rasika Nayanajith

Thank you so much for sharing these links, I was getting desperate not to find something like that with so many details about the UCS220-M5, fantastic!
I appreciate it.

[Carlos Rogerio Souza Santos]

Excellent publication, thank you very much!