Prime 3.10 reports that my 9120AXI units have 3 radios

[David Ritter]

Prime 3.10 report that my 9120AXI units have either 2 radios, a+b (xor)  Traditional or 3 radios a+b (Xor)+n  the 'n' defined as aux radio main

All my units are configured the same  with only one drawing 30w poe and 8 drawing 23.2.  Yes that 3 radio ap is reporting 30w but some of the 23.2 units are also reporting 3 radios.  One of them has flipped the xor radio to A. thus  operating a+a+n

Where is that AUX radio turned on or off?

[Rich R]

You don't mention what WLC you're using or what version of software?
Is this maybe the Bluetooth Low Energy (BLE) radio?
Check out: https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/17-2/config-guide/b_wl_17_2_cg/ble_beacons_in_ciscowave_2_access_points.html and
https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-10/config-guide/b_cg810/location_services.html
Those might help if it is the BLE radio.

[David Ritter]

Hi Rich,

the airos is 8.10.181.3.  I just checked and my 9117's are all depicted with the normal 2 'lobe' symbol.  however, when the 9117's were on the 9800-40, Prime depicted them with 3 lobes.

I don't have location enabled as the ap's name says it all and everything is working fine

Thank you