Prime Infrastructure WLC9800 AP Tags

[tsgruu2000]

Hi All,

We got access points with static Tags assigned. In Prime Infrastructure 3.8 I can see the Tags but I cannot find a way to edit them through Prime? The Tags are displayed in Device Details. Does anybody know if this is possible?

Thanks,

Regards,

Urs

[Scott Fella]

If a template is not available, then you can create a cli template that you can use to push the changes out.

[tsgruu2000]

Thanks a lot. So we will still edit the tags using the WLC CLI what's probably the easier way.

[Scott Fella]

Either one is easy, just depends on the person whom is running the job. If you know and understand the cli, that is easy, templates takes a bit to get use to, but in the end it’s all about pushing the settings properly.