cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
916
Views
0
Helpful
3
Replies

PrimeInfra not showing correct clients info from WLC

Wireless_Guy
Level 1
Level 1

Hi All,
Its been noticed the PrimeInfra is not showing the correct clients information from WLC when doing a live thsoot. Has anyone noticed this issue before and is there any fix for it ?

 

Thanks

3 Replies 3

Hi @Wireless_Guy

Try to sync up Prime and WLC and perform audit just to make sure. It is also a good idea stop/start Prime services sometimes.

 But if this is a bug, only through a TAC you can address this.

 

 

-If I helped you somehow, please, rate it as useful.-

Hi @Flavio Miranda

I'm planning to check the polling confi. However from Cisco PI document it says "If you receive a message that the client does not seem to be connected to any access point, you must reconnect the client and click Refresh."

 

 

Administration > Settings > Background Tasks page 
&
Administration > Settings > System Settings > Client and User > Client

 

 

https://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/3-1-3/user/guide/pi_ug/clientmgmt.pdf

 

Thanks,

I am afraid that it is not that easy. More than once I´ve been connected in some access point and later on tried to find myself on Prime and there was no record.

Unfortunately Prime has lots of problem. 

 

 

 

 

-If I helped you somehow, please, rate it as useful.-

Review Cisco Networking for a $25 gift card