05-21-2014 07:34 PM - edited 07-05-2021 12:53 AM
I have problem when I want to upgrade and setting my Access Point.
I can't change the Ip address of my AP to access it from web.
Sometimes my computer got bluescreen when I connect with USB serial / console cable.
Help how to change my AP from LWAPP to Autonomous AP and what IOS do I use to this AP.
05-21-2014 08:22 PM
05-21-2014 08:51 PM
I have read that and change the file name with c1130-k9w7-tar.default but AP cannot find that file from TFTP.
05-21-2014 10:01 PM
but AP cannot find that file from TFTP.
Can you tell me if the file is located in your default TFTP folder?
05-22-2014 04:24 AM
yes, i set the file located in default TFTP
05-22-2014 05:21 AM
Ok, do the entire process again. But this time, copy-and-paste the entire process. I want to see what you are doing and where it's failing.
05-22-2014 08:37 AM
05-22-2014 07:28 PM
It's really hard to point out to you where the problem is because you are posting screenshots.
When you released the button after 29 seconds, the AP automatically assigns itself a 10.0.0.1 IP address (as per instruction).
Two lines later, the AP tries to search for the file. But look at the line after that. It's a "connection timeout". This basically means the AP could not contact your TFTP server.
Maybe you need to check if Windows FW is enabled.
05-22-2014 10:05 PM
my firewall was enabled, but ap cannot connect to tftp
05-21-2014 10:54 PM
Check these post, It may helps.
If still getting problem then change the computer or laptop and try with that.
Dont forget to rate helpful posts
05-29-2014 12:45 PM
The problem may be, the AP could not contact your TFTP server.
Please check if Windows FW is enabled.
05-29-2014 08:27 PM
problem solved. extension file must be *.default
changing name for the file not running if the type file not change.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: