I want to use client application dscp value as input for the capwap dscp value. So, on the catalyst 9800 I configured it using cli on the AP Join Profile: qos-map trust-dscp-upstream. Now, for some reason the AP still gives the capwap packet the wrong value. I didn't disable anything before configuring it, it was on the fly. Now the EM 8.5 mobility guide does change settings on qos-maps (one of the changes is applying qos-map trust-dscp-upstream) when it got it's a and b network and the qos-mapping disabled.
So my question is: Do the new Join Profile settings only getting applied when I disable the a/b networks and the qos-mapping before changing the AP Join Profile? Or am I doing something wrong?
-If I helped you somehow, please, rate it as useful.-
Table of Contents
Table of ContentsOverviewConnecting a Catalyst 9800 WLC to Cisco DNA Center ManuallyConnecting an AireOS WLC to Cisco DNA Center ManuallyCisco DNA Center Assurance Deployment Guide References
The purpose of this document...
Securing devices without 802.1X
PSK (Pre-Shared-Key) WLAN is widely used for consumer & enterprise IoT onboarding as most of IoT device doesn’t support 802.1X. While PSK WLAN provides an easy way to onboard IoT, it also introduces challenges as...
Due to the certificate expiration, any new Control and Provisioning of Wireless Access Points (CAPWAP) or Light Weight Access Point Protocol (LWAPP) connection will fail to establish. The main feature that is affected will be the Acce...
Where to download
Attached files on this post
Alternatively, cloud version (only summaries)
New implementation for the WLC Config Analyzer. it is a new re-write of the application, with clean up and improved checks
Support for IOS...