cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
312
Views
0
Helpful
7
Replies
andris87
Beginner

"404 NOT FOUND" known bug. AP 2600i CLI wireless activation

Hi, i'm still here...

like @rrudling told me, latest firmware for many AP series have the "404 not found" bug, and also the ap3g2-k9w7-tar.153-3.JF15.tar for AP2600i has it! but i don't want the easiest way and i'm now asking you how to configure my access point wireless connections 2.4 and 5 by CLI. i want to use it to connect all my devices with wpa2-psk security like with a modem/router/AP of telephone operator.

tnx

1 ACCEPTED SOLUTION

Accepted Solutions
andris87
Beginner

i installed this ap3g2-k9w7-tar.153-3.JPM.tar

most of pages are ok but the one of ssid configuration no.... i followed this guide

https://www.youtube.com/watch?v=JkUfTXuwj2U&t=332s

without doing reset after installation of new firmware. one advice, remember that this 153-3.JPM, after installation, has http server off, so you have to activate before connect via GUI!

i tried some config of wifi (using GUI, this works!) but i can tell you all that this AP is slower than actual devices and 5ghz is less powerful, so it suffers a lot the walls in flat...today itsn't the best choice but is great to learn Cisco IOS (the GUI doesn't work!!!!)

View solution in original post

7 REPLIES 7
Leo Laohoo
VIP Community Legend