cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3424
Views
0
Helpful
2
Replies

"access point location command invoked" - AIR-LAP1252AG-N-K9

Sascha Goldner
Level 1
Level 1

Hi!

We got some serious issues to get APs running on a WLC 5508 (7.0.116.0). The APs were added and configured in the WCS, but no SSID can be found by clients (802.11b/g Network Status is enabled).

The radio led is blinking green on the APs which indicate that the "access point location command" has been invoked. What's the meaning of that?

thx in advance for you support.

2 Replies 2

Stephen Rodriguez
Cisco Employee
Cisco Employee

What WLAN ID did you configure?  DId you configure AP groups?  If so, you need to add the WLAN to the AP groups, as the first 16 are in the 'default group'

Steve

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

Hi Steve,

I defined an AP group different to the default group. I added two WLAN Profiles (ID 2 & 3) an put them into my AP group as well as the APs themselves.

br

Sascha

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: