09-25-2021 11:50 PM
Dear sir,
I don't know why "AIR-LAP1042N-K9L" always lost communication with the network device that just works as AP. Maybe it works in an environment full of iron racks. SO how to improve the communication quality?
And I want the have the manual about this device, but cannot find it on the website of cisco.
Solved! Go to Solution.
09-26-2021 01:39 AM
Hi,
1. to find blind spots and deployment places for APs, you need to do correct RF planning before AP deploy. that will make sure everyplace is covered with signal and seamless connectivity for wifi users.
2. this model is too old and EOL. you can replace them with new models which have enhanced features and support.
Good luck
rate this and mark as answer if this solved your concern
KB
09-26-2021 12:17 AM
>...but cannot find it on the website of cisco.
That is because this device is very old and no longer supported :
https://www.cisco.com/c/en/us/obsolete/wireless/cisco-aironet-1040-series.html
M.
09-26-2021 12:38 AM
Thank you,marce1000.
09-26-2021 01:39 AM
Hi,
1. to find blind spots and deployment places for APs, you need to do correct RF planning before AP deploy. that will make sure everyplace is covered with signal and seamless connectivity for wifi users.
2. this model is too old and EOL. you can replace them with new models which have enhanced features and support.
Good luck
rate this and mark as answer if this solved your concern
KB
09-26-2021 02:01 AM
Copy that, thanks for your advice.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: