cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
324
Views
10
Helpful
4
Replies
TekkenYang
Beginner

"AIR-LAP1042N-K9L" always lost communication with the network device

Dear sir,
     I don't know why "AIR-LAP1042N-K9L" always lost communication with the network device that just works as AP. Maybe it works in an environment full of iron racks. SO how to improve the communication quality?
   And I want the have the manual about this device, but cannot find it on the website of cisco.

1 ACCEPTED SOLUTION

Accepted Solutions
Kasun Bandara
Collaborator

Hi,

1. to find blind spots and deployment places for APs, you need to do correct RF planning before AP deploy. that will make sure everyplace is covered with signal and seamless connectivity for wifi users.

2. this model is too old and EOL. you can replace them with new models which have enhanced features and support.

 

Good luck

rate this and mark as answer if this solved your concern

KB

Please rate this and mask as answer, if this resolved your issue
Good luck
KB

View solution in original post

4 REPLIES 4
marce1000
VIP Advisor

 

              >...but cannot find it on the website of cisco.

 That is because this device is very old and no longer supported :

         https://www.cisco.com/c/en/us/obsolete/wireless/cisco-aironet-1040-series.html

 M.

  

Thank you,marce1000.

Kasun Bandara
Collaborator

Hi,

1. to find blind spots and deployment places for APs, you need to do correct RF planning before AP deploy. that will make sure everyplace is covered with signal and seamless connectivity for wifi users.

2. this model is too old and EOL. you can replace them with new models which have enhanced features and support.

 

Good luck

rate this and mark as answer if this solved your concern

KB

Please rate this and mask as answer, if this resolved your issue
Good luck
KB

View solution in original post

Copy that, thanks for your advice.

Create
Recognize Your Peers
Content for Community-Ad