"Failed to set P2PBlockingMode"...?

[craighowson]

Hi

I am trying to configure P2P Blocking Action to "drop" on our guest network but when trying to configure this it throws the following error (see below).

Any suggestions?

TIA

[Mark Elsen]

           - Please include controller & type/model + software version (?)

 M.

[craighowson]

We are using 2x 5520 WLC's and running OS 8.10.183.0

Thanks

[MHM Cisco World]

There is limitations of using p2p block and wlc HA.

MHM

[craighowson]

Ah, that might be the issue then.

Do you know where I might find information on this please? I have found the restrictions info in the 8.10.183.0 config guide but it doesn't mention anything about HA.

[Mark Elsen]

 - Take care of these restrictions : https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration-guide/b_cg75/b_cg75_chapter_01001011.pdf

 M.

[craighowson]

Thanks Marce1000, appreciate the info.

I have had a read of that document and the restrictions only seem to apply to Flexconnect AP's, which we are not using. All our AP's centrally switch and are configured in local mode.

I cannot seem to see anything that points towards the issue we are experiencing... unless I am missing something?