cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1247
Views
3
Helpful
5
Replies

Scheduling a powercycle of Wireless Access Points...

rcampb3ll
Level 1
Level 1

Hello.

In our environment we have two Cisco 5500 Series Wireless LAN Controllers, fourty-six Cisco 3500 Series Access Points, and use Cisco Wireless Control System for management.

Is there a way to schedule all forty-six Access Points to powercycle weekly during off-business hours?

Any guidance would be greatly appreciated.

Thanks!

1 Accepted Solution

Accepted Solutions

ok, in the AP templates there is a checkbox to reboot the AP.  So same scenario, just check the box and schedule it to run at whichever time you want.

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

View solution in original post

5 Replies 5

Stephen Rodriguez
Cisco Employee
Cisco Employee

Are you looking to turn of the AP so that they don't offer services?

You can use WCS templates to schedule the radios to be disabled, and another to enable them.

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

Thanks for the reply Steve.

We are looking for a reboot of the Access Points, not to turn them (or their services) off.

ok, in the AP templates there is a checkbox to reboot the AP.  So same scenario, just check the box and schedule it to run at whichever time you want.

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

Thanks again.

I'll look into the AP templates and see if I can get it figured out. As this is my first foray into WCS, there will be a bit of a learning curve I'm guessing.

If you don't fancy this, there is another way of doing this and it's via Cisco's EnergyWise.  Let's say you want to reboot your AP at midnight:

!Global

energywise domain security shared-secret

energywise importance 60

!  Time Range

time-range ON

absolute start 00:00 01 February 2013

periodic daily 0:01 to 23:59

time-range OFF

absolute start 00:00 01 February 2013

periodic daily 0:0 to 0:01

!  Interface

interface GigabitEthernet0/1

energywise level 10 recurrence importance 70 time-range ON

energywise level  0 recurrence importance 70 time-range OFF

energywise importance 60

Review Cisco Networking for a $25 gift card