04-25-2006 11:17 AM - edited 07-04-2021 11:59 AM
I have a new WLC2006 and new 1131AG access points. The access points reboot over and over again and the controller log shows:
Security processing of Image Data failed from AP xx:xx:xx:xx:xx and an error about /bsn/ap/1130c not being found. Thanks for any help.
04-25-2006 07:10 PM
Hi Matthias,
I experienced a similar problem too but with 1100 Access points.The controller runs 2.2.X.X firmware and i tried to upgrade it to 3.2, but get an error "Insufficient Flash Memory" after tftp files are downloaded.the controller works fine with Internal DHCP enabled.
Thanks and Regards,
Mohan
04-25-2006 07:30 PM
I just go off the phone with TAC and they sent me the most recent firmware and that fixed my problem for me. Thanks for your response though.
04-25-2006 07:33 PM
Many thanks for your quick reply!!would like to know how to upgrade the controller from the existing 2.2.X.X to the latest 3.2.X.X. Get an error "Ïnsufficient Flash Memory"after downloading the latest code.
Thanks and Regards,
Mohan
04-25-2006 07:37 PM
I didn't get the insufficient memory error. I was running 3.2.78 before updating, so . . .
I hope someone can help you though. I am very new at this.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide