01-25-2017 12:22 AM - edited 07-05-2021 06:25 AM
Hi,
i just wanted to know if it is possible for me to use the ironport S190 device in a manner where one of the connection will be serving
guest traffic only and other connection serving the secure internet traffic only.
the guest traffic is going through the anchor guest controller in DMZ and secure corporate traffic through the foriegn WLC.
01-25-2017 07:25 AM
when I look at the quick start guide, chapter-4 you cannot use the S190 to do the segragation into two different data-paths.
01-25-2017 11:18 PM
Hi Pieterh,
Thanks for the reference.
the chapter talks about different deployment models only.
I was wondering, if i use the model, transparent proxy with WCCP, i maybe will able to segregate the traffic i think ( i haven't tried that yet).
However, what i want to understand is, can i use the 2 ports to physically seperate the traffic. As in one port will only allow secure traffic and other will serve only to guest traffic.
in short i just want to understand how the duplex mode works. does it go for both ports in duplex mode so both ports can send and receive their respective traffic or in duplex mode, only T1 is active.
need clarification on this.
01-26-2017 01:50 AM
look again at the QST! port have a dedicated function
the device has two function each in two modes.
1) proxy
a) single port in/out (P1)
b) one port in one port out (P1/P2)
2) network monitor
a) single port in/out (T1)
b) one port in one port out (T1/T2)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide