Setting up AP1142N-A-K9 in an existing Wi-Fi Network

[carlscomputers1]

Greetings All!

I have a AP1142N-A-K9 that I picked up in a surplus lot and was wondering in I could use it to connect devices in a detached shop which has a switch which is connected to a Wi-Fi equipped modem with Cat 5 cabling?

The existing Network works fine, I just want to connect wireless devices in the shop which are out of range of the existing modem?

Thanks,

Carl

[Sandeep Choudhary]

Yes you can do it.

first check if this AP has autonomous image or lightweight image.

check : https://rscciew.wordpress.com/2014/01/04/understand-access-point-ios-images/

how to configure a autonomous AP:

https://rscciew.wordpress.com/2014/05/24/single-ssid-configuration-on-autonomous-ap/

Regards

Don't forget to rate helpful posts 

[Moin Ilyas]

https://supportforums.cisco.com/document/49351/upgrade-1142-lwap-autonomous

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/15-3-3/configuration/guide/cg15-3-3.html