03-06-2019 07:43 PM - edited 07-05-2021 10:00 AM
Hi Community,
Is it possible to SSH/Telnet to an Access Point (AP) via the Cisco Wireless LAN Controller (WLC) CLI?
I have performed a '?' at the '>' EXEC prompt and cannot see any valid options.
Regards,
Nathan.
Solved! Go to Solution.
03-06-2019 09:59 PM
Hi,
I dont recommand it but ....In a way, it is possible using "debug ap enable <AP name>" and then issue the commands by using "debug ap command <command in quote>".
Best way to just find out what is the IP address of the AP and then remote into the AP without the WLC because it is faster and less cumbersome.
Regards
Dont forget to arte helpful posts
03-06-2019 09:59 PM
Hi,
I dont recommand it but ....In a way, it is possible using "debug ap enable <AP name>" and then issue the commands by using "debug ap command <command in quote>".
Best way to just find out what is the IP address of the AP and then remote into the AP without the WLC because it is faster and less cumbersome.
Regards
Dont forget to arte helpful posts
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: