cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
901
Views
1
Helpful
7
Replies

Swport-4-MAC_CONFLICT

Chandan Singh
Level 1
Level 1

We are facing Swport-4-MAC_CONFLICT:Dynamic mac 001E.49FB.A4FF from Gig1 conflict with SVI ,check Network topology and make sure there is no loop.

WLC 9800 CL 17.9.4 ,AP 2702 (Local mode)

No HA single cloud WLC in ESxi platform server

PFA snap for Reference

ChandanSingh_0-1707390987630.png

Let me know if this is due to loop in network or Bug ,software version is New.

7 Replies 7

marce1000
VIP
VIP

 

 - Have a checkup of the WLC 9800 CL  controller configuration with the CLI command show tech wireless and feed the output into :
                                                                                                                                      Wireless Config Analyzer

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

pieterh
VIP
VIP

I see multiple interfaces and multiple source addresses in your screenshot
I guess the WLC port configuration does not match the ESXi switch configuration 

Virtual Wireless LAN Controller Deployment Guide 8.2 - Cisco
In ESXi, configure the appropriate networking needed to support vWLC. The recommendation is to use a trunk for Dataport, and an optional access port for the Service Port*, such as the example below:

 

 - @pieterh Looks like the document you refer too points to the aireos based vwlc , not the 9800CL , but I align with your options in the sense that I think that the WMI is not correctly configured , 

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

Hi @marce1000 marce1000
thank you for mentioning, I'll pay attention to this ,
I agree it's better to refer a document matching the model in the problem

JPavonM
VIP
VIP

Ensure you use Gi1 for management the box only, Gi2 for production, and Gi3 for HA and allow only the corresponding VLANs.

https://www.cisco.com/c/en/us/products/collateral/wireless/catalyst-9800-cl-wireless-controller-cloud/nb-06-cat9800-cl-wirel-cloud-dep-guide-cte-en.html#Deployingthe9800CLusingVMwareESXi

Take also care of this workaround when setting promiscous:

https://kb.vmware.com/s/article/59235

 

Rich R
VIP
VIP

This is also specifically covered in the Best Practices guide - basically G1 and G2 should be on separate virtual switches.  If you make both ports trunks on the same vswitch then you need to make sure both ports cannot see the same VLANs at all.
https://www.cisco.com/c/en/us/products/collateral/wireless/catalyst-9800-series-wireless-controllers/guide-c07-743627.html#C9800CLconsiderations

Chandan Singh
Level 1
Level 1

Thank you Everyone for your reply i will check all these options.

Review Cisco Networking for a $25 gift card