i am facing the issue with controller configuration with rest of the WLC and WCS. When i do the following task manually it sync and showing ideal in report:
1. Choose Configure > Controllers, and click the check box at the top of the IP Address list to choose all controllers. 2. From the Select a Command drop−down list, choose Save Config to Flash. 3. Click OK. This is a basic test to verify that SNMP works correctly, and the controllers will do as the WCS tells them. 4. Choose Configure > Controllers, and click the check box at the top of the IP Address list to choose all controllers. 5. From the Select a Command drop−down list, choose Refresh Config from Controllers. 6. Click OK.
But when i schedule it then it is showing mismatch but task is sussessful and not showing any failed task. I when i click it mismatch > audit now > recofigure sync by selecting readio button of controller then it shows succcessful and shows ideal.
Thank you for the overwhelming response to the First and Second EFT refresh of 8.10MR6!
We are excited to announce the third refresh of 8.10 MR6 EFT Program for PRODUCTION deployments.
While the CCO release of 8.10MR6 is just a few we...
Greetings!Thank you for the overwhelming response and feedback for the first 17.3.4 EFT/Beta release.
Now we are excited to announce the second refresh of 17.3.4 EFT/Beta Program for PRODUCTION deployments.
This release is the s...
It’s been about two and half years, since the launch of next generation Cisco Catalyst 9800 Wireless LAN Controllers that has the most deployment flexibility and runs the modular, scalable, highly reliable, open and programmable operating system, I...
Hi All, I have made this video for Cisco Pitch the Future Contest in Malaysia which talks about Wi-Fi 6 and EWC Demo. Please feel free to view the video below and please support me for this contest by giving the video a like as the Contest will end o...