cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1263
Views
5
Helpful
4
Replies

Tag Source - Filter Vs AP

Charlie Grey
Level 1
Level 1

hi,

new to C9800 controller.

like to ask the experts here which these are more preferred (less issue) and should be place on higher priority for AP Tag Source? AP or filter? especially when AP failover to other controller.

i m running code 17.3.3.

if using AP as source tag, i need to go in each individual AP to check tat checkbox.

appreciate if can share your experience.

thanks everyone.

 

1 Accepted Solution

Accepted Solutions

Rich R
VIP
VIP

And do not use version 17.3.3! Refer to https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/214749-tac-recommended-ios-xe-builds-for-wirele.html but I'd recommend going to 17.6.4 so you can use tag persistency https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/17-6/config-guide/b_wl_17_6_cg/m_ap_tag_persistency.html

View solution in original post

4 Replies 4

Leo Laohoo
Hall of Fame
Hall of Fame

We use AP filter.  

any particular reason?

thanks for replying.

Our AP names start with a site code.  

If we rename the APs to start with the site code, the filter will then start to work.

Rich R
VIP
VIP

And do not use version 17.3.3! Refer to https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/214749-tac-recommended-ios-xe-builds-for-wirele.html but I'd recommend going to 17.6.4 so you can use tag persistency https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/17-6/config-guide/b_wl_17_6_cg/m_ap_tag_persistency.html

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: