06-16-2022 12:09 AM
Dear All,
Good day.I would like to ask if it is a good technique assign the network address of the wlc management interface and dhcp-server into vlan 99 general management, i.e. configuring the vlan99 access port for the dhcp,wlc interfaces connected to the switch. I have also connected the wlc to the DC where the dhcp-server is located. I would greatly appreciate your advice.
Thanks
Best Regards
Solved! Go to Solution.
06-16-2022 06:56 AM
Hi
The wlc needs to in trunk mode. If PacketTracer supported flexconnect then you could use this setup. In FlexConnect you only need the management vlan reaching the wlc ad the client traffic stay on the access switch.
But, when the traffic goes to the wlc, you need create vlans for differents ssids then, the port need to be trunk.
06-16-2022 06:56 AM
Hi
The wlc needs to in trunk mode. If PacketTracer supported flexconnect then you could use this setup. In FlexConnect you only need the management vlan reaching the wlc ad the client traffic stay on the access switch.
But, when the traffic goes to the wlc, you need create vlans for differents ssids then, the port need to be trunk.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide