cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1230
Views
0
Helpful
6
Replies

Unable to join an AIR-CAP2702E-E-K9 to WLC5508

Ha Dao
Level 1
Level 1

Hi expert guys

I have new AP CAP2702E-E-K9 but can not join it the current WLC

After config IP, gateway and WLC address, it only show 

Translating "CISCO-CAPWAP-CONTROLLER"...domain server (255.255.255.255) on the console screen

Help me to check it

AP002c.c8ea.308c#show capwap ip config


LWAPP Static IP Configuration
IP Address 107.107.70.5
IP netmask 255.255.255.0
Default Gateway 107.107.70.1
Primary Controller 107.107.211.4

AP002c.c8ea.308c#ping 107.107.211.4
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 107.107.211.4, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/4 ms

6 Replies 6

Bill Klosa
Level 1
Level 1

On occasion we get an AP that will not join automatically. At that point I  use the following command on the AP in enable mode:

capwap ap controller ip address <ip address of controller>

Hi Bill, i also use that command: capwap ap controller ip address 107.107.211.4

LWAPP Static IP Configuration
IP Address 107.107.70.5
IP netmask 255.255.255.0
Default Gateway 107.107.70.1
Primary Controller 107.107.211.4

Connect a console cable to the AP and reboot the AP.  I want to see the entire boot-up and the WLC discovery process.

Hi Leo

Help me to check the AP boot up process, thank you so much

which method are you using to discover WLC by AP ?

Check this:

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/70333-lap-registration.html

Regards

Hmmmm ... Static IP address. 

In enable mode, enter this command "capwap ap primary <WLC Name> <WLC Management IP address>".

Review Cisco Networking for a $25 gift card