Unable to login to WAP

[mahesh18]

Hi Everyone,

I am unable to access the WAP.

When i try ssh it do not take current crendentials.

IS there any way that i can login to WAP via WLC?

Model of WLC is WLC2112-KP

Regards

MAhesh

[Rasika Nayanajith · Accepted solution]

Hi Mahesh,

You have to enable telnet/ssh to your AP. By default it is disabled.

Select your AP under wireless tab, & then in Advanced configuration of that AP you can enable that.If you want to override credentials (default Cisco/Cisco) you can do it in Credential tab of that AP.

HTH

Rasika

**** Pls rate all useful responses. That will contribute $1 from Cisco CSC to Kiva ****

[mahesh18]

Hi Rasika,

SSH is already enabled on AP.

My issue is i do not know pw to login to AP.

From WLC i went to AP and under general i found this

hardware reset.

What will happen if i click on hardware reset?

Will it lose its all current config?

Regards

MAhesh

[mahesh18]

Also under advanced i found Crendentails tab.

It has option override global crendentails

What will happen if i click on override global crendentials ?

will it reset the pw back to cisco cisco?

MAhesh

[Rasika Nayanajith · Accepted solution]

Hi Mahesh,

In this way you can configure new username, password & enable password for that  AP. This will simply override any global credential configured for APs through WLC.

In this way you should able to get access to this AP. Give it a try & see

HTH

Rasika

**** Pls rate all useful responses. That will contribute $1 from Cisco CSC to Kiva ****

[mahesh18]

That worked and i was able to reset the pw.

Regards

MAhesh

[Rasika Nayanajith]

Great... Thanks for rating as well

Rasika