cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
514
Views
0
Helpful
4
Replies
Highlighted
Enthusiast

Viewing Trustpoint on Converted 1131 Crashes AP

I converted an 1131 to LWAPP a while back and I'm using it in my lab today.  The controller doesn't accept it since I don't have the SSC hash.  I thought perhaps the command 'show crypto pki <certificate>' would show me the hash of the certificate.  The trouble is that when I run that command, the AP hangs immediately, is unresponsive for 30 - 60 seconds, dumps a crash log, and then reboots.  Any thoughts?

Regards,
Scott

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Enthusiast

Hey Scott, you need to issue debug pm pki enable to get the hash.

View solution in original post

4 REPLIES 4
Highlighted
Enthusiast

Hey Scott, you need to issue debug pm pki enable to get the hash.

View solution in original post

Highlighted

Thanks Kyle!

Highlighted
Enthusiast

Upgraded to the latest CAPWAP release and all is well...

Highlighted

I'm curious as to why the hash shown in the debug output differs from that of the output of the command I ran locally on the AP?  It shows 'Fingerprint SHA1' and that's what needs to be entered into the AP policy.

Content for Community-Ad