In our company we have Vlan and each floor have a specific IP range. For example, Florr 1 is 192.168.72.1 to 192.168.72.20 with Gateway 192.168.72.21 and floor 2 is 192.168.72.22 to 192.168.72.73 and Etc.
In each Floor we have an access point and the SSID of all are same, For example the SSID of all access point is "Cisco".Our problem is that Laptops and Cell phone IP address changed Time to Time because of Vlan and same SSID. I want to know how can I configure my Cisco access points to Solve this problem?
Table of Contents
Table of ContentsOverviewConnecting a Catalyst 9800 WLC to Cisco DNA Center ManuallyConnecting an AireOS WLC to Cisco DNA Center ManuallyCisco DNA Center Assurance Deployment Guide References
The purpose of this document...
Securing devices without 802.1X
PSK (Pre-Shared-Key) WLAN is widely used for consumer & enterprise IoT onboarding as most of IoT device doesn’t support 802.1X. While PSK WLAN provides an easy way to onboard IoT, it also introduces challenges as...
Due to the certificate expiration, any new Control and Provisioning of Wireless Access Points (CAPWAP) or Light Weight Access Point Protocol (LWAPP) connection will fail to establish. The main feature that is affected will be the Acce...
Where to download
Attached files on this post
Alternatively, cloud version (only summaries)
New implementation for the WLC Config Analyzer. it is a new re-write of the application, with clean up and improved checks
Support for IOS...