cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
546
Views
0
Helpful
6
Replies
Highlighted
Beginner

VLANs in WLC

HI,

I went through below link

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008073c723.shtml

I have the same setup except the dhcp.

I have dhcp server which is givng IP to clients; I want to divide clients as bulding 1 and building 2 with vlan

But they should get IP from same dhcp server

how can I do it?

6 REPLIES 6
Highlighted
Contributor

Have you created ap-group per building and did interface over-ride

Thanks

NikhiL

Highlighted

what is interface override???

I have lag enabled on wlc

Highlighted

Configure it like this

Create AP-Groups in the WLC for each of the building

Create dynamic interfaces for each building

Under WLAN>Ap-Groups, add each AP in each building, in the respective AP-Groups

Map the WLAN to the AP-groups to the interface for each building ( you can see an option, Add interface mapping in the document you sent)

Thanks

NikhiL

Highlighted

what about the vlan,

i need to configure vlan 4000 and 4001

first buldng aps will be in vlan 4000 and second bldng will be in 4001

right now i have only 4001 enabled

Highlighted

Create VLAN 4000 also and configure the AP port in VLAN 4000. If you want the client to get ip address in vlan 4000, create a dynamic interface in the WLC in vlan 4000 and map it to the WLAN

Thanks

NikhiL

Highlighted

Content for Community-Ad