WAP121 IP address changed and now cannot access configuration

[brentwallace]

I have a WAP121 Access Point that continues to work perfectly since installation in early 2014. I am unable to access the setup/configuration. I have the correct IP address for the AP as shown on the router's IP list but when trying to access the AP at that address I receive the message "192.168.1XX.XXX refused to connect" in my browser. Any suggestions for how to connect to this AP's setup/configuration?

[marce1000]

 - Can you ping that address ?

 M.

[brentwallace]

Thank-you for the response.

Yes. Ping results are 0% loss. Average 84ms round trip.

Brent

[Scott Fella · Accepted solution]

Are you sure that no other device is using that ip address?

[brentwallace · Accepted solution]

Problem solved by matching MAC address of AP to those listed on the IP list of the router and noting my use of incorrect IP. Can now access AP setup/configuration of AP.

Old lessons relearned. Thank-you for a goof first experience here.

[Scott Fella]

Glad you got it working.  Thanks for posting your solution.