Hi all,
I have an issue with a Wireless Bridge from a WLC2504 connected 2602 (Lightweight AP) to an Autonomous 2602 AP. For some reason, I cannot browse to HTTPS websites. The config on the Autonomous 2602 is as follows below. It only uses the 5ghz Dot11Radio1 for the WGB
[code]
no aaa new-model
clock timezone CET 1 0
clock summer-time BST recurring last Sun Mar 0:00 last Sun Oct 0:00
no ip source-route
no ip cef
!
dot11 syslog
!
dot11 ssid WGB
authentication open
authentication key-management wpa version 2
guest-mode
wpa-psk ascii 7 xxxxxxxxxxxx
!
no ipv6 cef
bridge irb
!
interface Dot11Radio0
no ip address
shutdown
antenna gain 0
station-role root
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
!
interface Dot11Radio1
no ip address
!
encryption vlan 1 mode ciphers aes-ccm tkip
!
encryption mode ciphers aes-ccm
!
ssid WGB
!
antenna gain 0
peakdetect
stbc
station-role workgroup-bridge
bridge-group 1
bridge-group 1 spanning-disabled
!
interface GigabitEthernet0
no ip address
duplex auto
speed auto
bridge-group 1
bridge-group 1 spanning-disabled
!
interface BVI1
mac-address c067.afc0.40f8
ip address 10.10.5.251 255.255.255.0
ipv6 address dhcp
ipv6 address autoconfig
ipv6 enable
!
ip forward-protocol nd
ip http server
no ip http secure-server
ip http help-path http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag
!
logging host 10.10.5.4
!
snmp-server community public RO
bridge 1 route ip
bridge 1 aging-time 1000000
!
[/code]
