Hi All ,
I test AP9136 with WLC 9800-40 but I found the 5Ghz Slot 2 Admin Disable and 6Ghz Radio Operation Status down .
For Policy Tag / Site Tag / RF Tag , I already configure not use default configuration .
Please advise me .
Solved! Go to Solution.
- Reboot the AP , just after boot connect to it and issue the command show logging ; check for additional info's,
>..- ROW with country Thailand (TH)
I don't know if this is related but if the particular regulatory domain does not support 6E the radio could remain disabled , according to https://www.wi-fi.org/countries-enabling-wi-fi-in-6-ghz-wi-fi-6e , Thailand is considering...
- Check the full AP model on the packing box (or on the AP) ; you may need extra configuring steps on the controller as in :
Even if the regulator allows the channel use doesn't mean Cisco has enabled it. It can take some time to get the product licensed and the software updated after the regulator has approved the band use.
show wireless country channels as per https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/17-9/config-guide/b_wl_17_9_cg/m_country_codes.html#reference_F57D65F840FE4756A3D545B3673B42D9 to check what channels are supported for your country on the WLC.
You can see the detailed data at https://www.cisco.com/c/en/us/support/wireless/catalyst-9136i-access-point/model.html#DataSheetsandProductInformation in the documents titled Detailed Channels and Maximum Power Settings ...
As you'll see from Detailed Channels and Maximum Power Settings for Cisco Catalyst 9136I Access Points, Release 17.11.1 in the "Country to tab mapping" tab Thailand currently has no 6GHz support even in 17.11
So the short answer - it's not currently supported. Your SE may be able to tell if/when support is planned.