09-17-2018 02:23 AM - edited 07-05-2021 09:11 AM
I was proposed following diagram for connection of wifi guest anhor:
Firewall-1: to restrict traffic between LAN and DMZ
Firewall-2: provider's device
Is it correct design when anchor is connecting by G1 interface towards firewall-1 and by G-2 interface - towards firewall-2? If it is correct would be good to have some related information.
09-17-2018 02:56 AM - edited 09-17-2018 02:58 AM
Pls refer below for wireless Geust anchoring. You require another controller in your LAN.
Also typically you connect WLCs to a switch. In your DMZ, you should have a switch where you define SVIs (unless that firewall is dedicated to wireless traffic termination)
HTH
Rasika
*** Pls rate all useful responses ***
09-17-2018 04:50 AM
yep,
I am not at that elementary level.
Local WLCs are on LAN.
VLAN is expected to be terminated on firewall-2.
The question: is it possible to use anchor as per diagram, one interface connected to firewall-1 and another is to firewall-2.
If I had a layer-3 switch I would not ask this question.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: