09-15-2017 06:16 AM - edited 07-05-2021 07:39 AM
Hi
Anyone here that got experience with configuring wirless guest authentication with fortiwlc(Meru) and Cisco ISE ?
If someone have some information or can give me a clue how to proceed with this it would be much appreciated
09-15-2017 05:49 PM
09-28-2017 06:20 AM
Thanks Francesco I wil try to set it up some day ;)
09-28-2017 05:13 AM
Hi there,
Did you manage to set this up? I'm looking to do the same.
Thanks
Tim
09-28-2017 05:16 AM
Hi
Yes, I did it using Cisco ISE 2.2 with DHCP scope.
The goal is that ISE gives IP addresses within a specific scope and it will add itself as dns server. Then it can catch all traffic and send a redirect.
This is the way I'm doing it and it works very well.
Sending the url redirect to the device, it's sometime a challenge depending on vendor.
Thanks
09-28-2017 06:21 AM
I have not been able to test this but i wil let you know when i have tested it out :) Hope you wil do the same :)
05-10-2018 11:44 AM
I've been tasked with trying to get MAB and 802.1X authentication working with our legacy Meru controllers (running version 7.x) using ISE2.4. Could you share some of the configuration around the disctionary/device profile you have configured?
09-26-2018 10:46 PM
Did you ever find any answers on this topic?
03-13-2021 10:38 PM
who know when when i change battery after run it shows below
ÿÿBBBBBBâBÂBBBBþ2BBBBþÿÏÿBBä##bBBòkÿBBBBBB?BBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBõBBBBBBBBBBBBÏÙBBBB¯BBBâ¯BBBâÿ¯BBBâʽr?±BBBBòÿ¯BBBâ¯BBBâÅýÿ¯BBBâ¯BBB?ýÿ -¨+^që=,],Õýµ³Ñ¬'?½±[f]î',¥,¥,U¥¥mR*r©*±¯¦õìJµ?(© ¬ ($´u¡4$G4$¡(Tl ²ì5sÔÄB K¡?>« ûBÄþ
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: