10-08-2012 08:38 AM - edited 07-03-2021 10:47 PM
I am trying to pass a WCS AP Template to my Test Mesh Root AP, when I try and apply the template, I get the following error:
Failure: MEDIATION-1,Attempt to set conflicting attribute value,LradIf,adminStatus,LradIf! followed by the mac address.
This is the first attempt to try and set a mesh Root AP up, any help would be appreciated.
thanks
nev
10-11-2012 12:35 PM
Neville,
What settings are you trying to push via Template on the 802.11b/g/n parameters?
10-14-2012 11:44 PM
This is the template I have passed to the RAP
10-13-2012 03:01 AM
Is the RAP up?
Are the RAP radios up?
How the RAP is powered?
Wireless>> All APs>> Select RAP>> click advanced - Under "power over ethernet settings" what option is selected. select the power injector if not already and try pushing the template.
10-14-2012 11:45 PM
Hi
The RAP is up, the error occurs when I try and enable the radios. The RAP is poered over ethernet directly from a 3750x with dual power. Any help would be welcome.
thanks
nev
10-15-2012 03:09 AM
The radios will not come up when powered up by a PoE switch. You need to use the power injector specifically for the MESH AP or hard wired to a power source.
http://www.cisco.com/en/US/docs/wireless/access_point/1550/power/guide/1550pwrinj.html
Powering up the 1550:
Thanks,
Scott
Help out other by using the rating system and marking answered questions as "Answered"
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: