WISM2 in Maintenance mode

[h.donlou]

After enable HA, both WISM2 modules are stay in Maintanance mode.

How can I undo this state.

[Scott Fella]

That is a known bug. Have you tried power cycling the WiSM2 modules? You have to maybe shut one down or both to get it out of maintenance mode. I know you have to remove AP SSO also and then re-enable that again. There isn't a good way to do it without powering down the WiSM2.

Sent from Cisco Technical Support iPhone App

[h.donlou]

I have already done that.

I powered down the secondary and reset the primary.

The primary stays in maintenace mode

[Yahya Jaber]

Hi,

can you please follow those guidelines for the WiSM2?

http://www.cisco.com/en/US/products/ps10315/products_tech_note09186a0080bd3504.shtml#vlan

[Tedwheat53]

What version are you running? We are having lots of problems running HA. Need to find non-buggy version

Sent from Cisco Technical Support iPhone App

[Scott Fella]

7.4.100.60 came out recently but its not 100% but better than all the others..

https://supportforums.cisco.com/docs/DOC-32259

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

[Tedwheat53]

Yea that is what we are currently running. Have had the default gateway not reachable twice as failover reason. Any problems with N+1 failover instead of HA SSO?

Sent from Cisco Technical Support iPhone App

[Scott Fella]

N+1 seems to work fine. AP SSO not so much.

Sent from Cisco Technical Support iPhone App