04-06-2013 05:03 AM - edited 07-03-2021 11:51 PM
After enable HA, both WISM2 modules are stay in Maintanance mode.
How can I undo this state.
04-06-2013 05:18 AM
That is a known bug. Have you tried power cycling the WiSM2 modules? You have to maybe shut one down or both to get it out of maintenance mode. I know you have to remove AP SSO also and then re-enable that again. There isn't a good way to do it without powering down the WiSM2.
Sent from Cisco Technical Support iPhone App
04-06-2013 05:21 AM
I have already done that.
I powered down the secondary and reset the primary.
The primary stays in maintenace mode
04-06-2013 05:59 AM
Hi,
can you please follow those guidelines for the WiSM2?
http://www.cisco.com/en/US/products/ps10315/products_tech_note09186a0080bd3504.shtml#vlan
05-16-2013 05:24 PM
What version are you running? We are having lots of problems running HA. Need to find non-buggy version
Sent from Cisco Technical Support iPhone App
05-16-2013 05:34 PM
7.4.100.60 came out recently but its not 100% but better than all the others..
https://supportforums.cisco.com/docs/DOC-32259
Thanks,
Scott
Help out other by using the rating system and marking answered questions as "Answered"
05-16-2013 05:39 PM
Yea that is what we are currently running. Have had the default gateway not reachable twice as failover reason. Any problems with N+1 failover instead of HA SSO?
Sent from Cisco Technical Support iPhone App
05-16-2013 10:50 PM
N+1 seems to work fine. AP SSO not so much.
Sent from Cisco Technical Support iPhone App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide